| Product Identification | Back to Contents | 【Product Name】
Orange sweet oil | 【Synonyms】
Neat oil of sweet orange
Neroli oil
Oil of sweet orange
Orange oil | 【CAS】
8008-57-9 | 【RTECS】
RI8600000 | 【RTECS Class】
Tumorigen; Natural Product; Primary Irritant | 【Beilstein/Gmelin】
NA |
| First Aid Measures | Back to Contents | 【Ingestion】
First aid is not normally required. If symptoms develop, seek medical attention. | 【Inhalation】
If symptoms develop, move individual away from exposure and into fresh air. If symptoms persist, seek medical attention. If breathing is difficult, administer oxygen. Keep person warm and quiet; seek immediate medical attention. | 【Skin】
Remove contaminated clothing. Wash exposed area with soap and water. If symptoms persist, seek medical attention. Launder clothing before reuse. | 【Eyes】
If symptoms develop, immediately move individual away from exposure and into fresh air. Flush eyes gently with water for at least 15 minutes while holding eyelids apart; seek immediate medical attention. |
| Handling and Storage | Back to Contents | 【Storage】
Keep tightly closed in a cool place in a tightly closed container. | 【Handling】
Containers of this material may be hazardous when emptied. Since emptied containers retain product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed. |
| Hazards Identification | Back to Contents | 【Inhalation】
Breathing of vapor or mist is possible. Breathing small amounts of this material during normal handling is not likely to cause harmful effects. Breathing large amounts may be harmful. | 【Skin】
May cause mild skin irritation. Prolonged or repeated contact may dry the skin. Symptoms may include redness, burning, drying and cracking of skin, and skin burns. This material is unlikely to pass into the body through the skin. | 【Eyes】
Can cause eye irritation. Symptoms include stinging, tearing, redness, and swelling of eyes. | 【Ingestion】
Swallowing this material is not likely to be harmful. | 【Hazards】
Vapors are heavier than air and may travel along the ground or be moved by ventilation and ignited by heat, pilot lights, other flames and ignition sources at locations distant from material handling point. Never use welding or cutting torch on or near drum (even empty) because product (even just residue) can ignite explosively. Dense smoke may be generated while burning. |
| Exposure Controls/Personal Protection | Back to Contents | 【Personal Protection】
Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots. | 【Respirators】
If overexposure has been determined or documented, a NIOSH/MSHA jointly approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators under specified conditions. | 【Exposure Effects】
Symptoms of exposure to this material through breathing, swallowing, and/or passage of the material through the skin may include: irritation (nose, throat, airways). |
| Fire Fighting Measures | Back to Contents | 【Flash Point】
49 | 【Fire Fighting】
Extinguish fire using regular foam, carbon dioxide, dry chemical. Wear a self-contained breathing apparatus with a full facepiece operated in the positive pressure demand mode with appropriate turn-out gear and chemical resistant personal protective equipment. |
| Accidental Release Measures | Back to Contents | 【Small spills/leaks】
Small Spill - Absorb liquid on vermiculite, floor absorbent or other absorbent material. Large Spill - Eliminate all ignition sources (flares, flames including pilot lights, electrical sparks). Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed. Stop spill at source. Prevent from entering drains, sewers, streams or other bodies of water. Prevent from spreading. If runoff occurs, notify authorities as required. Pump or vacuum transfer spilled product to clean containers for recovery. Absorb unrecoverable product. Transfer contaminated absorbent, soil and other materials to containers for disposal. |
| Stability and Reactivity | Back to Contents | 【Incompatibilities】
Acids, flourides, halogens, iodine, peroxides strong oxidizing agents, vinyl- and styrene-based plastics, Avoid high temperature contact with reactive monomers (i.e., methacrylates or vinyl chloride). | 【Stability】
Stable. | 【Decomposition】
Oxides of carbon. |
|
| Company Name: |
Spectrum Chemical Manufacturing Corp. |
| Tel: |
021-021-021-67601398-809-809-809 15221380277 |
| Fax: |
021-57711696 |
| WebSite: |
www.spectrumchemical.com/oa_html/index.jsp?minisite=10020&respid=22372&language=us |
|