물질구분: 유독물질; 혼합물(제품)함량정보: 사산화납(lead tetraoxide), 황산납(lead sulfate), 염기성탄산납(basic lead carbonate)을 제외한 납화합물(Lead compounds) 및 이를 25% 이상 함유한 혼합물. 다만, 초산납(lead acetate), 알킬화납(lead alkyls), 아지드화납(lead azide), 이초산납(lead di(acetate)), 메탄술폰산납(lead(Ⅲ) methansulfonate), 인산납(lead phosphate(3:2)), 스티핀산납(lead styphate)의 경우는 이를 0.5% 이상 함유한 혼합물
그림문자(GHS):
신호 어:
Danger
유해·위험 문구:
암호
유해·위험 문구
위험 등급
범주
신호 어
그림 문자
P- 코드
H373
장기간 또는 반복 노출되면 장기(또는, 영향을 받은 알려진 모든 장기를 명시)에 손상을 일으킬 수 있음
특정 표적장기 독성 - 반복 노출
구분 2
경고
P260, P314, P501
H410
장기적 영향에 의해 수생생물에 매우 유독함
수생 환경유해성 물질 - 만성
구분 1
경고
P273, P391, P501
예방조치문구:
P201
사용 전 취급 설명서를 확보하시오.
P273
환경으로 배출하지 마시오.
P308+P313
노출 또는 접촉이 우려되면 의학적인 조치· 조언를 구하시오.
NFPA 704
1
3
0
납(II) 브롬화몰 C화학적 특성, 용도, 생산
화학적 성질
white, ortho-rhomb crystal(s); -80 mesh with 99.999% purity; enthalpy of vaporization 133 kJ/mol; enthalpy of fusion 16.44 kJ/mol; obtained from PbO or PbCO3 and HBr; finds use as a photopolymerization catalyst and in photoduplication processes in the 365 nm region [KIR78] [CER91] [CRC10] [MER06]
물리적 성질
White orthorhombic crystals; density 6.66 g/cm3; melts at 373°C; forms a horn-like mass on solidification; vaporizes at 916°C; decomposes slowly on exposure to light; sparingly soluble in cold water (4.55 g/L at 0°C and 8.44 g/L at 20°C, respectively); moderately soluble in boiling water (44.1g/L at 100°C); Ksp 6.60x10-6 at 25°C; insoluble in alcohol; slightly soluble in ammonia; soluble in alkalies and also in sodium or potassium bromide solutions.
용도
It is used in the field of antirust, pigment and photograph. The molten lead(II) bromide acts as an electrolyte. Lead(II) bromide provides a high concentration of lead(II) ions and bromide ions to carry the current during the electrolysis process. The rare-earth-doped alkali-lead bromide crystals (potassium lead bromide (or) KPB; rubidium lead bromide or RPB) emerge as promising new low-phonon-energy host materials for mid-IR applications and are useful for solid state lasers. Hybrid organic/lead halide perovskites are promising materials for solar cell fabrication.
Purification Methods
Crystallise it from water containing a few drops of HBr (25mL of water per gram PbBr2) between 100o and 0o. A neutral solution is evaporated at 110o, and the crystals that separate are collected by rapid filtration at 70o and dried at 105o (to give the monohydrate). Its solubility in H2O is 0.5% (at ~10o) and 5% (at ~ 100o). To prepare the anhydrous bromide, the hydrate is heated for several hours at 170o and then in a Pt boat at 200o in a stream of HBr and H2. Finally it is fused [Clayton et al. J Chem Soc, Faraday Trans 1 76 2362 1980].
