- Lead dioxide
-
- $1.00 / 1KG
-
2019-07-11
- CAS:1309-60-0
- Min. Order: 1KG
- Purity: 98%
- Supply Ability: 1kg，5kg，100kg
|
| | Lead dioxide Basic information | | Uses |
| | Lead dioxide Chemical Properties |
| | Lead dioxide Usage And Synthesis |
| Uses | Lead (IV) oxide (PbO2) is also known as lead dioxide. It is a brown substance important in
the operation of the lead-acid storage battery. | | Description | Lead dioxide, PbO2, also plumbic oxide, is an odorless dark-brown crystalline powder which is nearly insoluble in water. It exists in two crystalline forms. The a phase has orthorhombic symmetry, lattice constants a=0.497 nm, b=0.596 nm, c= 0.544 nm, Z=4 (four formula units per unit cell). | | Chemical Properties | brown to black powder | | Chemical Properties | Lead dioxide is a dark brown crystalline solid
or powder. | | Physical properties | Red tetragonal crystals or brown powder; density 9.64 g/cm3; decomposes on heating at 290°C; practically insoluble in water; also insoluble in alkalis; moderately soluble in hydrochloric acid and also, in nitric acid-hydrogen peroxide mixture; slowly dissolves in acetic acid. | | Occurrence | Lead dioxide occurs in nature as the mineral plattnerite. It is used as an oxidizing agent in manufacturing dyes and intermediates. It also is used as a source of oxygen in matches, pyrotechnics, and explosives. In matches, the oxide is combined with amorphous phosphorus as an ignition surface. It also is used in making lead pigments, liquid polysulfide polymers and rubber substitutes. Lead dioxide electrodes are used in lead storage batteries in which lead dioxide accumulates on positive plates. | | Uses | Lead dioxide occurs in nature as the mineral plattnerite. It is used as an oxidizing agent in manufacturing dyes and intermediates. It also is used as a source of oxygen in matches, pyrotechnics, and explosives. In matches, the oxide is combined with amorphous phosphorus as an ignition surface. It also is used in making lead pigments, liquid polysulfide polymers and rubber substitutes. Lead dioxide electrodes are used in lead storage batteries in which lead dioxide accumulates on positive plates. | | Uses |
Industry
Application
Role/benefit
Electrochemistry
Regenerating potassium dichromate
Anode material/inexpensive and has high oxygen evolution over voltage
Electroplating copper and zinc in sulfate baths
Oxidation electrolytic by clarification Water
Production of glyoxylic acid from oxalic acid in a sulfuric acid electrolyte
Rubber
Vulcanized rubber
Vulcanizing agent
Chemical analysis
Organic elemental analysis and chromatographic analysis
Analytical reagent
Others
Production of matches, pyrotechnics, dyes
Additive
High-voltage lightning arresters
Resistor element
Coating of pipes
Helps to reduce lead contamination of drinking water
| | Uses | Lead dioxide is a strong oxidizing agent that is used in the manufacture of matches, pyrotechnics, dyes and other chemicals. It also has several important applications in the electrochemical industry, in particular as a component of lead–acid batteries used in almost all types of vehicles. | | Preparation | Lead dioxide is produced by oxidizing an alkaline slurry of lead monoxide with chlorine, sodium hypochlorite, or bleaching powder. Alternatively, it is obtained by passing chlorine into a hot aqueous suspension of lead sulfate and magnesium hydroxide. The ionic reaction is:
Pb(OH)3ˉ +ClOˉ → PbO2 + Clˉ+ OHˉ + H2O
It also is produced by electrolysis of acidic solutions of lead salts using a lead or platinum electrode. In such electrolytic process, lead dioxide is deposited on the anode of the cell.
Insoluble powdered lead dioxide also may be obtained when lead tetroxide is heated with nitric acid:
Pb3 O4 + 4HNO3 → 2Pb(N)3)2 + PbO2 + 2H2O
Lead dioxide also can be prepared by fusing lead monoxide with a mixture of sodium nitrate and sodium chlorate. | | General Description | Brown, hexagonal crystals. Insoluble in water. Used in matches, explosives, electrodes. | | Reactivity Profile | Noncombustible but accelerates the burning of combustible material. Reacts violently with hydrogen sulfide [Bretherick 1979. p. 977-978]. Ignites with hydroxylamine [Mellor 8:291. 1946-47]. Reacts violently with hydrogen peroxide [Mellor 1:937 1946-47], with phenylhydrazine [Mellor 7:637 1946-47], or with sulfuryl chloride [Mellor 10:676. 1946-47]. Reacts with incandescence with sulfur dioxide [Mellor, 1941, Vol. 7, 689]. Explodes when ground with boron or yellow phosphorus [Mellor, 1946, Vol. 5, 17]. Mixtures with sulfur and red phosphorus ignite [Mellor, 1941, Vol. 7, 689]. Reacts vigorously when heated with calcium sulfide, strontium sulfide or barium sulfide [Mellor, 1941, Vol. 3, 745]. | | Health Hazard | Toxic by ingestion. Inhalation of dust is toxic. Fire may produce irritating, corrosive and/or toxic gases. Contact with substance may cause severe burns to skin and eyes. Runoff from fire control or dilution water may cause pollution. | | Fire Hazard | These substances will accelerate burning when involved in a fire. May explode from heat or contamination. Some may burn rapidly. Some will react explosively with hydrocarbons (fuels). May ignite combustibles (wood, paper, oil, clothing, etc.). Containers may explode when heated. Runoff may create fire or explosion hazard. | | Potential Exposure | This material is used in electrodes for
lead-acid batteries; in matches; explosives, and as a curing
agent for polysulfide elastomers | | First aid | If this chemical gets into the eyes, remove anycontact lenses at once and irrigate immediately for at least15 min, occasionally lifting upper and lower lids. Seek medical attention immediately. If this chemical contacts theskin, remove contaminated clothing and wash immediatelywith soap and water. Seek medical attention immediately. Ifthis chemical has been inhaled, remove from exposure,begin rescue breathing (using universal precautions, including resuscitation mask) if breathing has stopped and CPR ifheart action has stopped. Transfer promptly to a medicalfacility. When this chemical has been swallowed, get medical attention. Give large quantities of water and inducevomiting. Do not make an unconscious person vomit.Antidotes and special procedures for lead: Persons with significant lead poisoning are sometimes treated with CaEDTA while hospitalized. This “chelating” drug causes arush of lead from the body organs into the blood and kidneys, and thus has its own hazards, and must be administered only by highly experienced medical personnel undercontrolled conditions and careful observation. Ca EDTA or similar drugs should never be used to prevent poisoningwhile exposure continues or without strict exposure control,as severe kidney damage can result.Note to physician: For severe poisoning BAL [BritishAnti-Lewisite, dimercaprol, dithiopropanol (C3H8OS2)] hasbeen used to treat toxic symptoms of certain heavy metalspoisoning. In the case of lead poisoning it may haveSOME value. Although BAL is reported to have a largemargin of safety, caution must be exercised, because toxiceffects may be caused by excessive dosage. Most can beprevented by premedication with 1-ephedrine sulfate(CAS: 134-72-5). | | storage | Color Code—Yellow: Reactive Hazard; Store in alocation separate from other materials, especially flammables and combustibles. Prior to working with this chemical you should be trained on its proper handling andstorage. Lead dioxide must be stored to avoid contact withoxidizers (such as perchlorates, peroxides, permanganates,chlorates and nitrates) chemically active metals (such aspotassium, sodium, magnesium and zinc), since violentreactions occur. Store in tightly closed containers in a cool,well-ventilated area away from combustible materials, suchas wood, paper, and oil. Lead dioxide is regulated byOSHA Standard 1910.1025. All requirements of the standard must be followed. See OSHA Standard 1910.104 andNFPA 43A Code for the Storage of Liquid and SolidOxidizers for detailed handling and storage regulations. | | Shipping | UN1872 Lead dioxide, Hazard Class: 5.1;
Labels: 5.1-Oxidizer. | | Incompatibilities | Lead dioxide is a powerful oxidizer.
Violent reaction with many compounds, including reducing
agents; chemically active metals; combustible materials,
strong acids, alkaline earth sulfides, aluminum carbides,
aluminum, amines, calcium sulfide, carbides, chlorine trifluoride, glycerin, hydrides, hydrochloric acid, hydrogen
peroxide, hydrogen sulfide, hydroxylamine, magnesium,
metal powders, metal sulfides, molybdenum, phenylhydrazine, phosphorous red/friction, phosphorous trichloride, silicon, sulfides, sulfur, sulfur dioxide, sulfur/friction, sulfuric
acid, tungsten, hydrogen trisulfide | | Waste Disposal | Conversion to soluble salt,
precipitation as sulfide and return to supplier. Do not discharge into drains or sewers. Dispose of waste material as
hazardous waste using a licensed disposal contractor to an
approved landfill. Consult with environmental regulatory
agencies for guidance on acceptable disposal practices.
Containers must be disposed of properly by following package label directions or by contacting your local or federal
environmental control agency, or by contacting your
regional EPA office. |
| | Lead dioxide Preparation Products And Raw materials |
|