ChemicalBook >>2,6-Dimethyl-5-heptenal>>2,6-Dimethyl-2-hepten-7-al(106-72-9)

2,6-Dimethyl-2-hepten-7-al(106-72-9)

2,6-Dimethyl-2-hepten-7-al(106-72-9)
Product IdentificationBack to Contents
【Product Name】

2,6-Dimethyl-2-hepten-7-al
【Synonyms】

Acetic acid, (3-methylbutoxy)-, 2-propenyl ester
Allyl (3-methylbutoxy)acetate
Prop-2-enyl 2-(3-methylbutoxy)acetate
【CAS】

67634-00-8
【Formula】

C10H18O3
【Molecular Weight】

186.25
【EINECS】

266-803-5
【Beilstein/Gmelin】

NA
Physical and Chemical PropertiesBack to Contents
【Appearance】

Clear colorless liquid.
【Melting Point】

-23
【Boiling Point】

218
【Density】

0.941 g/cm3 (20 C)
【Partition Coefficient】

1.88
First Aid MeasuresBack to Contents
【Ingestion】

If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician.
【Inhalation】

IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.
【Skin】

IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.
【Eyes】

First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.
Handling and StorageBack to Contents
【Storage】

Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.
【Handling】

All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.
Exposure Controls/Personal ProtectionBack to Contents
【Personal Protection】

Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.
【Respirators】

Where the neat test chemical is stored, weighed and diluted, wear an approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.
【Exposure Effects】

The toxicological properties of this material have not been investigated.
Fire Fighting MeasuresBack to Contents
【Fire Fighting】

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher.
【Fire Potential】

This chemical is combustible.
Accidental Release MeasuresBack to Contents
【Small spills/leaks】

If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. Then, use absorbent paper to pick up all liquid spill material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with 60-70% ethanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.
Stability and ReactivityBack to Contents
【Incompatibilities】

May react with strong oxidizing acids sufficiently exothermically to ignite the reaction products.
【Stability】

No data.
Company Name:Beijing Isomersyn Technology CO;LTD
Tel:010-82954736-
Fax:010-82954438
WebSite:www.isomersyn.com
Company Name:J & K SCIENTIFIC LTD.
Tel:010-82848833- ;010-82848833-
Fax:86-10-82849933
WebSite:www.jkchemical.com
Company Name:3B Pharmachem (Wuhan) International Co.,Ltd.
Tel:821-50328103-801
Fax:86-21-50328109
WebSite:
Company Name:Alfa Aesar
Tel:400-610-6006; 021-67582000
Fax:021-67582001/03/05
WebSite:chemicals.thermofisher.cn
Company Name:TCI (Shanghai) Development Co., Ltd.
Tel:021-67121386 / 800-988-0390
Fax:021-67121385
WebSite:www.tcichemicals.com/zh/cn/index.html
Company Name:Energy Chemical
Tel:021-58432009
Fax:021-58436166-800
WebSite:www.energy-chemical.com
Company Name:Shanghai Longsheng chemical Co.,Ltd.
Tel:021-58099637-8009;021-58099652-8005
Fax:021-58099609
WebSite:www.shlschem.com
Company Name:Shanghai Hanhong Scientific Co.,Ltd.
Tel:021-54306202- ;021-54308259-
Fax:+86-21-64545202
WebSite:www.chemto.com/ch/