no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
Move the victim into fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration and consult a doctor immediately. Do not use mouth to mouth resuscitation if the victim ingested or inhaled the chemical.
Take off contaminated clothing immediately. Wash off with soap and plenty of water. Consult a doctor.
Rinse with pure water for at least 15 minutes. Consult a doctor.
Rinse mouth with water. Do not induce vomiting. Never give anything by mouth to an unconscious person. Call a doctor or Poison Control Center immediately.
no data available
Butylglycolylbutyl phthalate was admin in diet to male sprague dawley rats, beagle dogs & miniature pigs in dose of 50 mg/kg for 21-28 days before oral admin of single dose of same cmpd labeled with (14)c in carbonyl group. it was excreted mainly in the urine in rats (77-83%), dogs (72-75%) and pigs (68-89%).
Water or foam may cause frothing.
no data available
Wear self-contained breathing apparatus for firefighting if necessary.
| HEALTH | 1 | Exposure would cause irritation with only minor residual injury (e.g. acetone, sodium bromate, potassium chloride) | |
| FIRE | 1 | Materials that require considerable preheating, under all ambient temperature conditions, before ignition and combustion can occur. Includes some finely divided suspended solids that do not require heating before ignition can occur. Flash point at or above 93.3 °C (200 °F). (e.g. mineral oil, ammonia) | |
| REACT | 0 | Normally stable, even under fire exposure conditions, and is not reactive with water (e.g. helium,N2) | |
| SPEC. HAZ. |
Avoid dust formation. Avoid breathing mist, gas or vapours.Avoid contacting with skin and eye. Use personal protective equipment.Wear chemical impermeable gloves. Ensure adequate ventilation.Remove all sources of ignition. Evacuate personnel to safe areas.Keep people away from and upwind of spill/leak.
Prevent further spillage or leakage if it is safe to do so. Do not let the chemical enter drains. Discharge into the environment must be avoided.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Store the container tightly closed in a dry, cool and well-ventilated place. Store apart from foodstuff containers or incompatible materials.
no data available
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Wear tightly fitting safety goggles with side-shields conforming to EN 166(EU) or NIOSH (US).
Wear fire/flame resistant and impervious clothing. Handle with gloves. Gloves must be inspected prior to use. Wash and dry hands. The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it.
If the exposure limits are exceeded, irritation or other symptoms are experienced, use a full-face respirator.
no data available
ODORLESS
115°C(dec.)(lit.)
345°C/5mmHg(lit.)
no data available
no data available
199°C(lit.)
no data available
no data available
no data available
no data available
log Kow = 4.15 (est)
7.07X10-6 mm Hg at 25 deg C (est)
no data available
no data available
Extremely light stable.
Slight, when exposed to heat or flame; can react with oxidizing materials.
no data available
no data available
When heated to decomp it emits acrid smoke and irritating fumes.
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
no data available
AEROBIC: Butyl glycolyl butyl phthalate at an initial concentration of 1 mg/L underwent approximately 95% biodegradation in 2 days under aerobic conditions in Mississippi River water. When 5, 20, 100 and 200 mg per 24 hr butyl glycolyl butyl phthalate was added to a semi-continuous activated sludge apparatus, it underwent >99% biodegradation under aerobic conditions(1,2). Butyl glycolyl butyl phthalate underwent 84.5% biodegradation in a semi-continuous activated sludge test under aerobic conditions in 24 hrs, and complete degradation was observed in three days in an activated sludge die-away test(3).
An estimated BCF of 300 was calculated in fish for butyl glycolyl butyl phthalate(SRC), using an estimated log Kow of 4.15(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is high(SRC). However, bioconcentration studies on compounds which are structurally similar suggest that bioconcentration may be lower than that indicated by the regression-derived equations due to the ability of aquatic organisms to readily metabolize this class of compounds(4).
Using a structure estimation method based on molecular connectivity indices(1), the Koc of butyl glycolyl butyl phthalate can be estimated to be 1.5X10+4(SRC). According to a classification scheme(2), this estimated Koc value suggests that butyl glycolyl butyl phthalate is expected to be immobile in soil.
no data available
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: UN1711 (For reference only, please check.)
IMDG: UN1711 (For reference only, please check.)
IATA: UN1711 (For reference only, please check.)
ADR/RID: XYLIDINES, LIQUID (For reference only, please check.)
IMDG: XYLIDINES, LIQUID (For reference only, please check.)
IATA: XYLIDINES, LIQUID (For reference only, please check.)
ADR/RID: 6.1 (For reference only, please check.)
IMDG: 6.1 (For reference only, please check.)
IATA: 6.1 (For reference only, please check.)
ADR/RID: II (For reference only, please check.)
IMDG: II (For reference only, please check.)
IATA: II (For reference only, please check.)
ADR/RID: No
IMDG: No
IATA: No
no data available
no data available
The information in this MSDS is only applicable to the specified product, unless otherwise specified, it is not applicable to the mixture of this product and other substances. This MSDS only provides information on the safety of the product for those who have received the appropriate professional training for the user of the product. Users of this MSDS must make independent judgments on the applicability of this SDS. The authors of this MSDS will not be held responsible for any harm caused by the use of this MSDS.