Aniline--Health Hazard and Toxicity

Sep 5,2019

Description

Aniline is an organic compound with the formula C6H5NH2. Consisting of a phenyl group attached to an amino group, aniline is the simplest aromatic amine. Its main use is in the manufacture of precursors to polyurethane and other industrial chemicals. Like most volatile amines, it has the odor of rotten fish. It ignites readily, burning with a smoky flame characteristic of aromatic compounds.

Toxicity Data

LD50 oral (rat) 350 mg/kg

PEL (OSHA) 35 ppm (27 mg/m3)

TLV-TWA (ACGIH) 25 ppm (17 mg/m3)

STEL (ACGIH) 35 ppm (27 mg/m3)

Health Hazard    

Exposures to aniline on inhalation, ingestion and/or through skin contact cause adverse health effects. Exposures to liquid aniline cause mild irritation to the skin and eyes. Aniline is a blood toxin and its absorption through the skin and by inhalation of its vapor results in systemic toxicity, damage to the kidney, liver, bone marrow and of methemoglobinemia. The symptoms of poisoning include, but are not limited to, drowsiness, dizziness, severe headache, nausea, tiredness, bluish discoloration of the lips and tongue, loss of appetite, irregular heart beat, mental confusion, and shock. A prolonged period of exposure to the vapor results in respiratory paralysis, convulsions, coma, and death.

Toxicity

Ammonia solutions are extremely corrosive and irritating to the skin, eyes, and mucous membranes. Exposure by inhalation can cause irritation of the nose, throat,and mucous membranes. Exposure to high concentrations of ammonia vapor (above approximately 2500 ppm) is life threatening, causing severe damage to the respiratory tract and resulting in bronchitis, chemical pneumonitis, and pulmonary edema, which can be fatal. Eye contact with ammonia vapor is severely irritating,and exposure of the eyes to ammonium hydroxide can result in serious damage and may cause permanent eye injury and blindness. Skin contact can result in severe irritation and burns; contact with the liquid results in cryogenic burns as well.

Ingestion of ammonium hydroxide burns the mouth, throat, and gastrointestinal tract and can lead to severe abdominal pain, nausea, vomiting, and collapse.

Ammonium hydroxide has not been found to be carcinogenic or to show reproductive or developmental toxicity in humans. Chronic exposure to ammonia can cause respiratory irritation and damage.

Flammability and Explosibility

Ammonia vapor is slightly flammable (NFPA rating = 1) and ignites only with difficulty. Ammonia forms explosive mixtures with air in the range 16 to 25%.Water, carbon dioxide, or dry chemical extinguishers should be used for ammonia fires.

Reactivity and Incompatibility

Highly explosive nitrogen halides will form in reactions with halogens, hypohalites,and similar compounds. Reaction with certain gold, mercury, and silver compounds may form explosive products. Violent reactions can occur with oxidizing agents such as chromium trioxide, hydrogen peroxide, nitric acid, chlorite, chlorate, and bromate salts. Exothermic and violent reactions may occur if concentrated ammonium
hydroxide solution is mixed with strong acids, acidic metal and nonmetal halides,and oxyhalides.

Storage and Handling

Ammonium hydroxide should be handled in the laboratory using the "basic prudent practices" described in Chapter 5.C. All work with this substance should be conducted in a fume hood to prevent exposure by inhalation, and splash goggles and impermeable gloves should be worn at all times to prevent eye and skin contact. Containers should be tightly sealed to prevent escape of vapor and should be stored in a cool area separate from halogens, acids, and oxidizers. Containers stored in warm locations may build up dangerous internal pressures of ammonia gas.

Accident

In the event of skin contact, immediately wash with soap and water and remove contaminated clothing. In case of eye contact, promptly wash with copious amounts of water for 15 min (lifting upper and lower lids occasionally) and obtain medical attention. If ammonium hydroxide is ingested, obtain medical attention immediately. If large amounts of ammonia are inhaled, move the person to fresh air and seek medical attention at once. In the event of a spill, soak up ammonium hydroxide with a spill pillow or absorbent material, place in an appropriate container, and dispose of properly. Alternatively, flood the spill with water to dilute the ammonia before cleanup. Boric, citric, and similar powdered acids are good granular neutralizing spill cleanup materials. Respiratory protection may be necessary in the event of a large spill or release in a confined area.

Disposal

In some localities, ammonium hydroxide may be disposed of down the drain after appropriate neutralization and dilution. In a fume hood, the concentrated solution should be diluted with water to about 4% concentration in a suitably large container, and neutralized with a nonoxidizing strong acid such as HCl. The resulting solution can be discharged to the sanitary sewer. If neutralization and drain disposal are not permitted, excess ammonium hydroxide and waste material containing this substance should be placed in an appropriate container, clearly labeled, and handled according to your institution's waste disposal guidelines.

  • Related articles
  • Related Qustion
  • The Versatility of Aniline in Various Industries Jul 13, 2023

    Aniline is a versatile compound used in tissue engineering, pharmaceutical production, and dye synthesis. It enhances cellular activity but poses health risks, requiring proper safety measures.

  • The Solubility of Aniline Nov 18, 2022

    The passage introduces the solubility of Aniline.

  • What is Aniline? Sep 22, 2021

    Aniline is an organic compound with the formula C6H5NH2. Consisting of a phenyl group attached to an amino group, aniline is the simplest aromatic amine. It is an industrially significant commodity chemical, as well as a versatile starting

See also

Ammonium hydroxide (NH4OH) is a solution of ammonia in water. Commonly called ammonia or ammonia water, the chemical is used as a cleanser and in manufacturing plastics, rubber, fertilizer and textiles.It's a colorless, clear liquid with a....

Sep 5,2019Inorganic chemistry
4

Sodium fluoride is colorless crystals or shiny white powder, belongs to tetragonal system, is positive hexahedral or octahedral crystals. It is slightly soluble in alcohol, soluble in water. Aqueous solution is acidic. It dissolves in hydro....

Sep 6,2019Inorganic chemistry

Aniline

62-53-3

Aniline manufacturers

  • Aniline
  • 62-53-3 Aniline
  • $5.00 / 1mL
  • 2024-01-08
  • CAS:62-53-3
  • Min. Order: 1mL
  • Purity: 99%
  • Supply Ability: 5000L
  • Aniline
  • 62-53-3  Aniline
  • $16.00 / 1kg
  • 2024-01-08
  • CAS:62-53-3
  • Min. Order: 1kg
  • Purity: 99.60%
  • Supply Ability: 50tons
  • Aniline
  • 62-53-3 Aniline
  • $100.00 / 1kg
  • 2023-09-13
  • CAS:62-53-3
  • Min. Order: 1kg
  • Purity: 0.99
  • Supply Ability: 20 tons